GUIDE TO INSTALLATION AND OPERATION
FIO-1901-RT |
13
3.3.4 The
Output & Optical
panel
Output Config
Manually select the source for the optical output; either the
optical receiver or the electrical input.
•
Normally, the optical output is connected to the
electrical input. This panel allows the user to select
the optical input as the source. In this configuration,
the FIO-1901-RT will extract the signal and place it on
its electrical output, and then send the optical signal
out to another destination.
•
This option exists in the WDM version, but is of little
practical use
The electrical output is always connected to the input from
the optical receiver.
Optical Config
Use the radio buttons to switch the optical transmitter ON or
OFF.
3.3.5 The
Factory/Presets
panel
Click the
Load Factory
button to reset all parameters on this
FIO-1901-RT card to factory default values.
•
The factory default values are shown underlined in the
menu found in the Annex to this document, beginning
on page 21.
User Presets
The FIO-1901-RT has memory registers which can hold up
to 5 user-defined parameter settings.
Select
any one of the five presets using the pull-down list.
The name of the currently-selected User Preset is shown on
the name bar.
Click
Load
to load the contents of the selected User Preset
into the FIO-1901-RT. All parameter settings and values will
be replaced by the contents of the selected User Preset.
Click
Save
to store the current parameter settings and
values from the FIO-1901-RT into the selected User Preset.
The existing contents of the preset will be overwritten
without asking for confirmation.
Figure 3.6
Output & Optical panel
Figure 3.7
Factory / Presets panel
