GUIDE TO INSTALLATION AND OPERATION
6
| FIO-1901-RT
The FIO-1901-RT-SRP single-slot rear panel, mounted in a Densité 2 or Densité 3 frame, incorporates these
connectors:
•
One socket for inserting a fiber transmitter/receiver SFP module – see the list of supported modules below.
•
One BNC connector for the 3G/HD/SD SDI input
•
One BNC connector for the 3G/HD/SD SDI output
2.3 SFP
Modules
The FIO-1901-RT supports the following SFP optical interface modules:
FIO-1901-RT Model #
Description of associated SFP module
FIO-1901-RT-S13-LC
Dual fiber Rx/Tx cartridge 1310 nm – LC/PC connectors
FIO-1901-RT-W13-LC Single
fiber
Rx/Tx cartridge with WDM (Tx=1310 nm; Rx=1550 nm) – LC/PC connectors
FIO-1901-RT-W15-LC Single
fiber
Rx/Tx cartridge with WDM (Tx=1550 nm; Rx=1310 nm) – LC/PC connectors
See
ANNEX 2 – Installing the Optical Interface
, beginning on page 22, for instructions on installing and removing SFP
modules.
Note that when the WDM (Wavelength Division Multiplexing) module is installed, the optical input and output signals –
one at 1310 nm and the other at 1550 nm – are multiplexed onto a single optical fiber.
Figure 2.1
FIO-1901-RT-SRP Rear Panell
