GUIDE TO INSTALLATION AND OPERATION
12
| FIO-1901-RT
3.3.2 The
Status
panel
This panel reports the status of this FIO-1901-RT card, its
rear panel, its SFP module, and the signals arriving at the
electrical inputs on the rear panel.
OPTICAL IN and ELECTRICAL IN
•
Shows the incoming data rate when a signal is
successfully received (green icons)
•
Identifies No Signal or No Lock conditions (red icons)
Rear Type – the data box identifies the rear panel installed
in the Densité frame for this FIO-1901-RT.
Rear mismatch – the icon is green when a compatible rear
panel is installed and red when an incompatible rear panel is
installed.
SFP - the data box identifies the SFP module installed in the
rear panel for this FIO-1901-RT.
SFP mismatch – the icon is green when a compatible SFP
module is installed and red when an incompatible SFP
module is installed.
SFP Info – the data boxes in this section give information
about the SFP module itself, and measured data about the operating status of the receiver RX and the transmitter TX.
3.3.3 The
Reclocker
panel
Use the radio buttons to enable reclocking of the video data
stream on the optical and electrical inputs independently.
The reclocker operates at the video standard rates of
SD (270 Mbps), HD (1.485 Gbps), and 3G (2.97 Gbps):
ON – reclock the data before passing it to the output
BYPASS – pass the data stream through without reclocking
Figure 3.4
Status panel
Figure 3.5
Reclocker panel
