GUIDE TO INSTALLATION AND OPERATION
FIO-1901-RT |
9
3.2.3.1 Output
Configuration
Normally, the optical output is connected to the electrical input. However, this menu item allows the user to select the
optical input as the source. In this configuration, the FIO-1901-RT will extract the signal and place it on its electrical
output, and then send the optical signal out to another destination.
Optical Tx
[ELECTRICAL IN, Optical Rx]
This option exists in the WDM version, but is of little practical use.
3.2.3.2 Optical
Tx
Turn the optical transmitter OFF or ON
Optical Tx
[OFF, ON]
3.2.3.3 Reclocker
Enable reclocking of the video data stream on the electrical input or the optical receiver. The reclocker operates at the
video standard rates of SD (270Mbps), HD (1.49Gbp), and 3G (2.97Gbps).
Electrical IN: [ON, BYPASS]
Optical Rx:
[ON, BYPASS]
3.2.3.4 User
Presets
The FIO-1901-RT has five data storage registers that can save the device configuration. Each register can be saved
independently by the user, and the device can be reconfigured from the contents of any of the registers by the user.
LOAD: [USER1, USER2, USER3, USER4, USER5] Load the contents of the preset into the FIO-1901-RT
SAVE: [USER1, USER2, USER3, USER4, USER5] Save the configuration of the FIO-1901-RT into the preset
3.2.3.5 Configure
Alarms
For each of the configurable alarms listed in the menu:
OPT Rx NO LOCK
(Optical receiver not locked)
OPT Rx NO SIGNAL
(Optical receiver no signal)
ELE.IN NO LOCK
(Electrical input not locked)
ELE.IN NO SIGNAL
(Electrical input no signal)
OPT Rx PWR WARN
(Optical receiver power warning)
OPT Rx PWR ERR
(Optical receiver power error)
SFP TEMPERATURE
(temperature on the SFP module)
R/SFP MISMATCH
(any mismatch between the card type / rear panel type / installed SFP module type)
NO SFP
(no SFP module installed)
Select the way in which it will be displayed on the card-edge Status LED.
Alarm level: [GREEN, YELLOW, RED, FLASH RED]
For each alarm, select whether it will be reported on the GPI output of the frame controller.
Alarm report: [NONE, GPI]
