EC9535 GSC Node Bus Converter • User’s Guide
9
2. Installation
When setting up an EC9535 GSC Node Bus Converter for the first time, or reconfiguring an exist-
ing configuration, there are certain steps that must be performed. It is recommended that initial
installation and later reconfiguration tasks be performed in a specific order to avoid possible com-
plications.
Perform installation and reconfiguration tasks in the following order. If you are reconfiguring, only
perform the step related to the configuration you are changing:
1 Mount the EC9535 in a rack. See
Rack Mount
on page 10.
2 Make connections between the EC9535 and the SMS7000 system controller. See
Making Sys-
tem Controller Connections
on page 11.
3 Make connections between the EC9535 and the router. See
Making Router Connections
on
page 12.
4 Make diagnostic connections. Diagnostic connections enable the router and UniConfig to com-
municate. This is important when initially configuring the router and any time the router is
reconfigured. See
Making Diagnostic Connections
on page 13.
5 Connect the alarm connection on the router to an external indicator. See
Making System Alarm
Connections
on page 15.
6 Connect power. See
Connecting to Power
on page 16.
7 Install UniConfig. If reconfiguring, UniConfig does not need to be reinstalled. See the UniCon-
fig User’s Guide.
Package Contents
When your EC9535 products from Miranda arrive, immediately inspect the shipping container for
any obvious damage. If the container is damaged, unpack and inspect the contents. If the contents
are damaged, notify the carrier immediately.
When unpacking the shipping container, look for the packing slip and compare it against the con-
tents to verify that everything ordered was received. If anything is missing (or if equipment is dam-
aged unrelated to shipping), please contact Miranda. For contact information, see
Technical
Support Contact Information
on page iii.
The package does not contain a mounting rack, network cables, mounting screws, or grounding
wire.
Summary of Contents for EC9535
