EC9535 GSC Node Bus Converter • User’s Guide
19
3. Configuration
Before being placed into service, the EC9535 must be configured for your particular router control
system and settings. Configuration is managed through UniConfig, which resides on a PC and is
separate from the router. For information on using UniConfig, see the
UniConfig User’s Guide
. For
instructions on configuring EC9535, see the section “Configuring EC9535” within the
UniConfig
User’s Guide.
When configuring the EC9535, the EC9535’s ‘CTRL 1’ serial port must be set to the same baud
rate as the controlled router’s ‘CTRL 1’ serial port rate. (See
Serial Control Connections
on page
3.) By default, the NV8288, NV8288-Plus and NV8500 Family routers have the ‘CTRL 1’ ports set
to 38,400 baud. However, the number of destinations that can be switched per frame in a system
using a SMS7000 system controller, an EC9535, and a NV8288, NV8288-Plus or NV8500 Family
router is determined by the EC9535 and the router serial port baud rates. Because higher rates may
be used, you may want to set the serial ports at the highest available rate (115,200 baud) unless
doing so results in communication errors. For information on setting the serial port baud rates for
routers, see the “Setting Up Communication” section within the
UniConfig User’s Guide.
Summary of Contents for EC9535
