4
IMPORTANT SAFETY INFORMATION
1. Warning!
1.1
Products manufactured by us are safe and without risk provided they are
installed, used and maintained in good working order in accordance with our
instructions and recommendations.
1.2
THIS APPLIANCE MUST BE EARTHED.
MAKE SURE SUPPLEMENTARY
BONDING COMPLIES WITH THE "REQUIREMENTS FOR ELECTRICAL
INSTALLATIONS".
In accordance with the current edition of 'The Plugs and Sockets etc. (Safety)
Regulations' in force at the time of installation, this appliance is intended to be
permanently connected to the fi xed electrical wiring of the mains system.
1.3
DO NOT
twist the individual cable cores of the live and neutral conductors, as
this will prevent them from entering the terminal block.
1.4
The shower unit must not be fi tted where it may be exposed to freezing
conditions. Make sure that any pipework that could become frozen is properly
insulated.
1.5
DO NOT
operate this appliance if it appears to be frozen. Allow the appliance
to thaw and then contact your installer before using again.
1.6
DO NOT
operate this appliance if water leaks from the Case. Maintenance may
be required before the appliance can be safely used.
1.7
DO NOT
fi t any form of outlet fl ow control as the outlet acts as a vent for the
tank body. Only Mira recommended outlet fi ttings should be used.
1.8
There are no user serviceable components beneath the cover of this appliance.
Only a competent tradesperson should remove the cover.
1.9
If any of the following conditions occur, isolate the electricity and water supplies.
Contact your installer or refer to 'To contact us', on the back page of this
guide.
1.9.1
If the cover is not correctly fi tted and water has entered the appliance
case.
1.9.2
If the case is damaged.
1.9.3
If the appliance begins to make an odd noise, smell or smoke.
1.9.4
If the appliance shows signs of a distinct change in performance,
indicating a need for maintenance.
1.10
Isolate the electrical and water supplies before removing the cover.
1.11
Mains connections are exposed when the cover is removed.
1.12
Refer to the wiring diagram before making any electrical connections.
1.13
Make sure all electrical connections are tight, to prevent overheating.
