29
28
Install the screws top and bottom to
secure the slide bar in position.
4
Install the falling supply tube.
Note: The falling supply tube may
need to be shortened, use a hacksaw
to shorten tube. Make sure the rough
end is concealed in the ceiling.
5
Note: When shortening pipework for use with any push-fit fitting, follow
manufacturer’s guidelines for finishing and cleaning the pipe.
7
a. Fit the shower hose to the end of the slide bar assembly.
Note: Do not fit the handshower until after pipework has been fully flushed
through. Refer to ‘Commissioning’.
b.
Fit the shower hose to the handset. Make sure that you fit the shower hose and
flow regulator.
8
a. Feed the plastic tube up through the slide bar and into the ceiling.
b. Push and twist plastic pipe end until it “clicks” and locks in place.
Caution! Do not allow any debris to block the plastic pipe.
Note: If plastic pipe requires shortening make sure there is enough length to
fit elbow (supplied) or alternative push-fit/compression fittings (not supplied).
6
Elbow
(supplied)
Flow Regulator
Washer
Washer
Elbow (supplied)
Summary of Contents for Mode Maxim
Page 26: ...50 Notes...
