6
Installation
1
3
2
Once the desired location has been
tested, mark the centre position and
draw a vertical line using a spirit level
to assist in the alignment of the remote
button.
Drill a 6mm hole into the wall and insert
the wall plug.
Apply silicone sealant around the hole
before inserting the wall plug.
Note: The remote button must be
installed on a flat and even wall
surface avoiding any grout lines.
Push the screw cap in to the wall plate.
Locate the wall plate so that the two
notches are aligned to the vertical line
on the wall and secure using supplied
screw. Tighten the supplied screw by
hand.
Note: The remote operates wirelessly. Its range is impacted by walls, ceiling
and different building materials. Test that the remote button operates at the
desired location before installing.
6 mm
Cap
Wall Plate
