6 GB
The spout can be swiveled to your desired
position. Make sure the spout is always
positioned within the area of the sink,
otherwise escape of water can lead to
serious flooding to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is
not too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using
the product. Keep all the safety advice
and instructions in a safe place for future
reference!
Installation
Installing the tap
Turn off the main water supply to prevent
serious leakage of water. Allow any
remaining water in the pipework to drain.
Install the tap as shown in Figs. A to F.
m
CAUTION!
Do not bend the hoses or place
them under tension. Otherwise material
damage could result.
Flushing the tap
The tap must be flushed through before first
use to remove any dirt. To do this, follow
these steps (see Fig. H):
Screw the aerator
2
off.
Open the main water supply and allow the
water to run for two minutes.
Then screw the aerator
2
on again.
Setting the temperature limiter
The cartridge
22
in this product has a temperature
limiter. This function is not activated in the factory
(neutral setting).
m
CAUTION!
Change the temperature limiter
setting only after the tap has been installed.
Follow Fig. G to set the temperature
limitation.
Turn off the main water supply.
Remove the small plastic cover
18
carefully
by a small flat screwdriver.
Release the locking screw
19
by turning it
anticlockwise using a hexagonal key.
m
CAUTION!
Do not take the screw
completely out; just loosen it until the control
lever
17
can be easily taken off.
Take off the control lever
17
.
Loosen the cartridge covering ring
20
by
hand. Then, screw off the cartridge retaining
ring
21
by using a pipe wrench.
Now pull the cartridge
22
upwards with the
help of a screwdriver.
Note:
Do not remove the cartridge
22
.
Place the setting ring
15
in the desired
position (see Fig. I).
Tighten the cartridge retaining ring
21
onto
the tap body
16
again by using a pipe
wrench. Then, tighten the cartridge covering
ring
20
by hand.
Place the control lever
17
back on to the tap
body
16
. Tighten the locking screw
19
by
turning it clockwise using a hexagonal key.
Press the small plastic cover
18
into the
opening.
Turn on the main water supply and check the
temperature limiter.
Operation
Bringing into use
Note:
If the fitting has not been used for a long
period flush the pipes through thoroughly in order
to avoid stagnation and build-up of residues in
the drinking water supply.
Open the main water supply.
Lift the control lever
17
and swing it to the
right or left in order to regulate the speed or
temperature of the water flow.
Check operation of the mixer. For this
purpose move the control lever
17
in all
possible positions. Please regularly check all
connections to ensure that they are tight.
