Warning! Do not use side brush in a room with no wall skirting, otherwise, the wall will get dirty.
Accessories
Transporter
Side Brush
Upkeep of your PORT A SCRUB
To get the maximum life of the machine ensure the following.
Regularly inspect sheath, plug and cord anchorage for damage or loose connection.
For maximum life wash the brushes regularly. Ensure machine is in Transport mode when not in use. Store
additional brushes in a vertical position to avoid bending of bristles. Check for permanent bending of bristles
in a particular direction. This may occur if the machine is operated for several days without removing the
brushes, which is not recommended. If this occurs, reverse the brush so that the bent bristles are
automatically straightened.
This may wear out after years of use. If this occurs the water collection performance will decrease. It should
be replaced by an authorized ServiceAgent.
The filter prevents clogging of the spray nozzle and should be periodically cleaned. Use pressurized air/
water for cleaning.
If the spray of the nozzle become blocked, slide the nozzle cover off and remove nozzle wash in clean water
and clean using a pin and refit.
·
Supply cord
Brushes
Wiper Blade
Solution feed filter
Nozzle maintenance
·
·
·
·
9
Warning!
Empty all liquid from the machine before using the transporter.
The simply fitted trolley provides for ease of movement when transporting the machine.
Installing the Transporter
1.With the machine handle in the upright position place the transporter centrally
alongside the machine.
2.By holding the machine firmly, strap the velcro with the machine to fix the transporter.
3.Ensure that the velcro strap properly wrapped around the bottom handle.
4.Now the transporter is ready to use. The machine can then be maneuvered easily
whilst holding the top handle.
To wash the edges, the side brush shall be used. Switch off and unplug the machine
before fitting the side brush.
1. Remove the front brush and brush shaft.
2. Fix the shield assembly and screw it into the side plate and tighten.
3.Insert the side brush through the shield and main brush.
Fitting the side brush
Using the side brush
1. Tilt the machine at an angle move forward. This way, the dirty water thrown bythe side brush will be collected by
the rear brush.
2. Use side brush only for washing the edges.
Summary of Contents for m12110
