2
3
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS !
Thank you for purchasing this power protection product. It has been de-
signed and manufactured to provide many years of trouble free service. Please
read this manual before installing your BPRTXL Battery Pack, models
BP192RTXL, BP240RTXL as it provides important information that should be
followed during installation and maintenance of the Battery Packs and batter-
ies allowing you to correctly set up your system for the maximum safety and
performance. Included is information on customer support and factory ser-
vice if it is required. If you experience a problem with the Battery Packs
please refer to Obtaining Service section in this manual to collect enough
information so that the Technical Support Department can rapidly assist you.
WARNING:
Risk of Electrical Shock. Hazardous live parts inside these Bat-
tery Packs are energized from the battery.
CAUTION!
This Battery Pack series is
ONLY
intended to be installed in an
indoor temperature controlled environment that is free of conductive contami-
nants. This Battery Pack series is not for use in a computer room as defined
in the Standard for the Protection of Electronic Computer/Data Processing
Equipment ANSI/NFPA 75. Select a location which will provide good air circu-
lation for the Battery Pack and UPS at all times.
WARNING:
These Battery Packs contains potentially hazardous voltages.
Do not attempt to disassemble the Battery Pack beyond the battery replace-
ment procedure. These Battery Packs contain no user serviceable parts.
Repairs and Battery replacement must be performed by
QUALIFIED SER-
VICE PERSONNEL ONLY.
CAUTION! DO NOT USE THE MOUNTING BRACKETS TO LIFT THE BAT-
TERY PACK.
The mounting brackets are
ONLY
for securing the Battery Pack
to the rack.
Chapter 1: Introduction
CAUTION!
The maximum ambient operating temperature for this Battery Pack
series is 40°C (“0 ~ 40°C” for Ambient Operation).
The external vents and openings on the Battery Pack are provided for ven-
tilation. To ensure reliable operation of the UPS and to protect the UPS
from overheating, these vents and openings must not be blocked or cov-
ered. Do not insert any object into any of the vents or openings that may
hinder the ventilation.
Install the Battery Pack in a well ventilated area, away from excess mois-
ture, heat, dust, flammable gas or explosives.
Leave adequate space (at least 15cm) around all sides of the Battery
Pack for proper ventilation.
Do not mount the Battery Pack with its front or rear panel facing down at
any angle.
Before usage, you must allow the Battery Pack to adjust to room temper-
ature (20°C~25°C or 68°F~77°F) for at least one hour to avoid moisture
condensing inside the UPS.
WARNING: Qualified Service Personnel ONLY
must perform the Installa-
tion and Servicing of these Battery Packs. MINUTEMAN accepts no liabilities
and is not limited to: injury to the Service Personnel, or damages to; the Bat-
tery Pack, the UPS, or the connected equipment caused by the incorrect
installation or servicing of the Battery Packs. These Battery Packs MUST be
operated with their respective UPS models, see the table below:
BP240RTXL
UPS
ED8000RT-CU
ED10000RT-CU
Battery
Pack
BP192RTXL
ED5000RT-CU
ED6000RT-CU
CAUTION!
To de-energize the Battery Pack:
1.
If the UPS is on press and release the On/Off/Test button.
2.
Turn off the input breaker on the rear panel of the UPS.
3.
Turn off the DC breaker on the rear panel of the Battery Pack.
4.
Disconnect the battery cable from the rear panel of the UPS.
5.
To de-energize the Battery Pack completely, disconnect the batteries.
