indoor bicycle trainer resistance unit – instruction manual
(ver.1.2 2018/5)
This is an upgrading unit to change your Minoura trainer to the latest SMART trainer that allows you to enjoy the
virtual courses and competitions on the internet.
Please be sure this is just a resistance unit. Refer your own trainer's instruction manual how to mount and use the
bike correctly.
• The supplied resistance unit needs to be attached to the frame before use.
The unit is very heavy and special care must be taken not to drop the unit. Be especially careful of the
flywheels (one at each end. One chrome, one black) dropping or otherwise hindering the unit will affect the
balance of the unit and void any warranty. Each unit is carefully and fully checked and in full working order
prior to being packaged.
• Adjust the roller pressure to the rear tire properly in order to maximize your tire life.
Tire and roller contact will eventually wear both your tire and the trainer roller.
Wipe the tire surface to remove any solid dust away before setting the bike on the trainer in order to maximize
both the tire and the drive roller life. Minoura recommends adding 10% more air to your tire when training.
• Avoid using your brakes to stop your workout. Let the flywheel come to a stop naturally. Using your brakes
will cause damage to the unit and your tire, possibly causing it to burst.
• Be careful not to pinch your finger when raising up or folding down the resistance unit, or folding the frame.
• Touching the spinning wheel and/or any other moving parts while training may cause serious injury.
Keep children, pets, towel and clothings away from the trainer when in use.
• This product requires electric power souce AC 100 – 240V. Do NOT apply any moisture or mud to the electric
magnet unit. Keep clean and avoid any dust even when using indoors.
If your electric plug shape is different from the supplied one, please use appropriate plug adapter.
• LST9200 has two different resistance systems; the electric magnet and the physical neodymium magnet.
When using the electric magnet as a smart trainer, adjusting the resistance level can be done only by the
Contact
- 1 -
If you need support, please first contact the shop you purchased this product from or contact
the distributor in your country for assistance. A list of our distributors can be found here:
http://www.minoura.jp/english/support/shop/distributor.html.
If you need further support, contact us at one of the places listed below.
MINOURA North American Tech Center
MINOURA Japan Headquraters
(for U.S. residents ONLY)
(for ALL customers)
Hayward, California, U.S.A.
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone: 1-510-538-8599 (8 am - 5 pm, Mon - Fri, PST)
Fax: +81-584-27-7505
Fax:
1-510-538-5899
Email: [email protected]
Email: [email protected]
Web: www.minoura.jp
Made in Japan
Important Notes
Please read carefully before use
