- 3 -
1
2
ASSEMBLING YOUR TRAINER
Prior to assembly of the Mag Unit, locate the two
bolts and two washers. Find the left-side slot on the
trainer. While placing the Mag Unit at the recom-
mended position on the inside of the slot, attach it
with the bolts and washers by using the included hex
wrench.
(see Fig. B)
After installing the Mag Unit, put the Height Adjust
Knob (this is optional) through the hole on the left
side slot, and then tighten it to the thread on the Mag
Unit’s support base. This optional Height Adjust
Knob will help you adjust the height of the Mag Unit
so that the rubber roller will fit properly on the rims
side wall. (see Fig.C)
Open the frame and U-Leg and place on level floor.
(Fig. C)
(Fig. A)
Mag Unit
Installation
Slot
Mag Unit
Rubber Foot Cap
Drive Roller
Couplings
U-Leg
Frame
Assistant Roller
Unit Installation
Slot
Drive-pulley
Lever
Mag Unit Height
Adjust Knob
Assistant Roller
Hub-clamp Handle
(Fig. B)
(This figure is type-D)
Load Adjust
Dial
