- 8 -
Increase
Decrease
How To Operate Remote Shifter
FG540 comes with a convenient remote shifter device.
By installing it on your handlebar or stem, you can adjust the resistance
level in 13 levels without getting off the bike.
The plastic band is soft enough to fit aero-shaped carbon handlebar or
round shaped stem as well as the standard round dimension handlebars.
How to install the remote shifter
1) Loop the plastic band around the handlebar
2) Hook the tip to the edge on the plastic shifter base
①
3) Flip up the lever to lock
②
How to increase the resistance level
Twist the shifter dial toward "H" symbol
How to reduce the resistance level
Twist the shifter dial toward "L" symbol
!
"L" does not mean no resistance. Due to the tire contact
to the roller, there will still be some small resistance.
The remote shifter is pre-adjusted to fit the standard handlebar size;
22mm (7/8") diameter.
If it becomes loose or too tight, or you need to install the shifter onto an
oversized handlebar or stem, adjust the band length by turning the plastic
screw with an M4 hex wrench.
How To Adjust Cable Tension
If you cannot shift at L or H position, it's time to adjust the cable tension.
1) Set the remote shifter lever at "H" position and straighten the cable.
2) Pull off the black plastic cap on foot of the cable, then the adjusting
screw with two lock nuts will appear.
3) While pushing the outer cable toward the shifter, push the adjusting
screw to the outer cable.
4) Turn the left side lock nut until it touches the Mag unit. You should
not overtighten the nut, otherwise you won't be able to set the shifter
at "L" position.
5) Turn the right side lock nut until it touhes the left side nut, then twist
the nuts each other to be locked as the method of "Double Nut".
6) Put the plastic cap over the screw again.
Lock
Lever
Indicator
(red dot)
1
2
!
Do not overtighten the plastic screw. It will break
the plastic band. Release the hook before adjusting.
You must release the
hook for adjusting screw.
4mm Hex
Wrench
Required Tool :
8mm Spanner
(not included)
x 2
Required Tool :
4mm Hex Wrench
(not included)
Cap
Adjust Screw
Lock Nut x 2
Turn the nut and tighten
