MINOLTA-QMS MAGICOLOR 2210, Installation Manual

Page: 38 / 48

Troubleshooting 34
Eng
li
s
h
The printer
is not
receiving
data from
the com-
puter. (The
Data indi-
cator
doesn’t
blink after
a file is
sent.) The printer is not on
line. Put the printer on line and check if the mes-
sage window displays
IDLE
.
The emulation has
been changed from
ESP to an emulation
that doesn’t match the
file you are sending. Print a status page from the control panel.
The printer
is printing
codes or
not printing
at all when
in ESP
mode. The printer emulation
is not correct. Reconfigure the port to the specific printer
emulation of the file you are trying to print.
Your ESP timeout is
too short. If a PostScript file prints PostScript statements
while the printer is in ESP mode, increase the
ESP timeout.
If you continue to have problems with the ESP
mode selecting the appropriate printer emula-
tion, contact Technical Support. Refer to the
Service & Support Guide.
Top cover
does not
close. The fuser oil roller
release lever is not set
in the correct position. Open the top cover and turn the fuser oil roller
release lever (two locations) to the locked
position, then close the cover gently to avoid
jarring the printer.
Front
cover does
not close. The transfer belt right
release lever is not set
in the correct position. Turn the right release lever clockwise to the 10
o’clock position, then close the front cover.
The waste toner is not
set correctly. Remove the waste toner, then reinstall it cor-
rectly.
Waste
toner pack
cannot be
installed. The transfer belt left
release lever is not set
correctly. Turn the left release lever clockwise to the 2
o’clock position, then install the waste toner.
The laser lens cover is
not installed, or was
not installed correctly. Reinstall the laser lens cover.
Toner car-
tridge car-
ousel will
not turn. The toner cartridge
carousel dial is turned
clockwise. Turn the carousel dial counterclockwise.
Symptom Cause Solution