MINOLTA-QMS MAGICOLOR 2210, Installation Manual

Page: 20 / 48

Plugging in/Turning on the Printer 16
Eng
li
s
h
Plugging in/Turning on the Printer
1
Make sure
the printer is
turned off.
2
Plug the printer
power cord into the
printer and into the
dedicated,
grounded,
surge-protected
electrical outlet.
WARNING!
Do not overload the outlet. For products installed outside North
America, do not connect the groundwire to gas or water pipes or
grounding for telephones.
3
Turn on the printer.
5 "
In compliance with UL guidelines, “The appliance inlet is con-
sidered to be the main disconnect device.”
After a brief warmup, your printer prints a startup page and displays
“
IDLE
” on the message window. If “
IDLE
” is not displayed in the
message window after the power switch is turned on, the setup oper-
ation is not proceeding correctly or the printer may be malfunctioning.
Recheck the setup. If the startup page doesn’t print or the print qual-
ity is not good, skip ahead to “Troubleshooting” on page 32.
5 "
The printer automatically switches to power-saving mode after
30 minutes of inactivity. In the Administration/Engine/Energy
Saver menu, you can change the number of minutes before the
printer switches to
power-saving mode.