2.16 Using Control Representation Mode
The Control Representation Mode is used to print out unprocessed data
or commands sent from the host computer. This procedure is sometimes
referred to as ‘‘dumping.’’ The printing of unprocessed data (in the form
of characters and symbols) is convenient for debugging programs. If a
specified character is undefined, a hexadecimal representation is printed.
This section explains how to print the character listing. For additional
information about Control Representation Mode, consult the
Digital ANSI-
Compliant Printing Protocol Level 3 Programming Reference Manual
.
NOTE:
If the file does not fill the page buffer completely, the remaining
data can be printed by pressing
On Line
to place the printer off line, and then
pressing
Form Feed
to print the partial page.
2.16.1 Entering Control Representation Mode
Use the procedure in Table 2–6 to place the printer in Control
Representation Mode.
Table 2–6: Entering Control Representation Mode
Operation
Display Reads
1. Press
On Line
to place the
printer off line.
— The On Line indicator
shuts off.
00 READY
2. Press and hold
Reset
for about
10 seconds.
03 RESET
03 DUMP
03 RESET
00 READY
DUMP
The printer is now in Control Representation Mode and ready to accept
data or commands from the printer. To exit Control Representation Mode,
perform a soft reset (see Section 2.17).
2–48
DEClaser 2200 Printer Operator’s Guide
Summary of Contents for Magicolor 2200 DeskLaser
Page 67: ...Figure 2 5 Test Print A MLO 004895 Figure 2 38 36 picas Operating Information 2 39 ...
Page 71: ...Figure 2 6 Test Print B MLO 004852 Figure 2 39 36 picas Operating Information 2 43 ...
Page 226: ...Figure C 2 Serial Connections to Modem MLO 004885 Figure C 2 19 picas Specifications C 5 ...
