Minnich M-BOX, Instructions Manual

Page: 6 / 17

M-Box Manual
6
GENERAL SAFETY
∆ DO NOT expose vibrator to rain.
∆ DO NOT use vibrator motor in damp or wet
locations without proper electrical circuits.
∆ DO NOT immerse the motor part in con-
crete.
∆ ALWAYS keep clear of rotating or moving
parts while operating.
∆ NEVER leave the machine unattended while
running
∆ ALWAYS disconnect the motor from the
power source when not in use, before servic-
ing, and when changing flexible shafting and
vibrator heads.
∆ Allow the machine to cool
before servicing. Contact with
hot components can cause
serious burns.
∆ Before Each use, ALWAYS check the motor
to make certain that there are no damaged
parts and that all parts function properly.
If any damage or malfunctioning parts are
found, have them repaired or replaced by an
authorized service facility.
∆ ALWAYS secure forms. Make sure the form
work is well made and braced to withstand
the stresses made by vibration.
∆ ALWAYS keep vibrator motor clean for bet-
ter and safer operation.
∆ ALWAYS store equipment properly when
it is not being used. Equipment should be
stored in a clean, dry location out of reach
of children and unauthorized personnel.
∆ Use only factory authorized replacement
parts.
∆ Store idle vibrator motor. When not in use,
motor should be stored in a dry, safe stor-
age area.
ELECTRICAL SAFETY
∆ Power tools must match the outlet. NEVER
modify the plug in any way. DO NOT use the
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets
will reduce risk of electric shock.
∆ Avoid contact with earthed or grounded
surfaces such as pipes, radiators ranges and re-
frigerators. There is an increase risk of electric
shock if your body is earthed or grounded.
∆ DO NOT expose power tools to rain or wet
conditions. Water entering a power tool will
increase risk of electric shock.
∆ DO NOT abuse power cord. NEVER use the
cord for carrying, pulling or unplugging the
power tool. Keep cord away from heat, oil
sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric
shock.
∆ When operating a power tool outside use an
extension cord suitable for outdoor use. Use of
a cord suitable for outdoor use reduces the risk
of electric shock.
∆ This unit is double-insulated. The double in-
sulation between the electric-conducting part
and the outside frame makes grounding un-
necessary. However, if parts are replaced with
wrong parts or assembled incorrectly, the ma-
chine may become unsafe to operate. Use only
Minnich Recommended replacement parts.
∆ When applicable, use a protection wiring de-
vice such as a Ground Fault Circuit Interrupter,
for the protection of personnel.
∆ Operate electric motor only at the specific volt-
age indicated on the nameplate.
∆ DO NOT spray water onto electric motor.
∆ DO NOT yank the cord to disconnect it from
the receptacle. Grasp the plus itself to discon-
nect it.
∆ ALWAYS make sure the ON/OFF switch is in the
OFF position hen not in use, and before insert-
ing the power plug into an AC replacement.
∆ Before plugging the motor into a power source,
ALWAYS remove any wrenches or other tools
from the motor, shaft, and head that were used
for assembly.