![background image](http://html.mh-extra.com/html/minn-kota/talon-10/talon-10_owners-manual_1802709014.webp)
14 | minnkotamotors.com
©2014 Johnson Outdoors Marine Electronics, Inc.
The spike for your Talon comes with a lifetime guarantee, with two years of labor covered for repair.
See the warranty section of the manual for further details.
TO REPLACE
1. Extend the spike out so that the second stage
begins to exit the bottom of the anchor. This may
require removing the anchor from the mounting
bracket, and laying the anchor horizontally or on a
flat surface.
NOTE:
The 12' and 10' Talon Tilt Bracket accessory (part number 1810222)
is available to make this process easier. With this accessory, you don’t have
to remove the Talon from the mount to replace the spike.
2. You will need to remove two (2) retainer pins in
order to replace the spike. First remove the spike
isolator restrainer pin, and slide the spike isolator
out from the bottom of the second stage. Next,
remove the spike retainer pin.
3. Remove the spike from the anchor. (You will not
need to retain the O-ring from the spike you are
replacing. The new spike will include a
replacement O-ring.)
4. Place the new spike into position along with the
replacement O-ring. When the spike is fully seated
into the anchor, the O-ring should be slid up to the
face of where the spike is held. Be sure to align
the retainer groove on the spike with the retainer
pin hole.
5. Slide the spike isolator up the spike and into the
second stage. Carefully replace the spike isolator
retainer pin.
6. Carefully replace the spike retainer pin, making sure
the ends of the pin are recessed on both sides.
Tools Required:
•
Pin Punch ⁄"
•
Hammer
•
Allen Wrench 2mm
SERVICE AND MAINTENANCE
REPLACING THE SPIKE
1.
2.
3.
4.
5.
6.