8 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high-speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
Clipped
Clipped
Washer
Washer
Power Tilt
Power Tilt
Top
Top
Plate
Plate
Cam Lever
Cam Lever
Inboard
Inboard
Stainless
Stainless
Steel Screw
Steel Screw
g. Start with the right side of the Ulterra, where the
Power Tilt is located. There are three Mounting Slots
in the Base Extrusion. These will be used to slide
the Ulterra onto the mounting hardware after it is
installed in the Top Plate (Assembly #C). Ensure that
the Cam Lever on the Top Plate points inboard.
h. Install the Top Plate to the Base Extrusion using
three Stainless Steel Screws (Item #4), three Clipped
Washers (Item #2201725), and three Nylock Nuts
(Item #6). Insert the Screws into the Top Plate from
the bottom up. Place a Clipped Washer on the end
of each Screw, leaving at least 1/4" space between
the Top Plate and Clipped Washer to allow the Base
Extrusion to slide under the Clipped Washers and
into place. Ensure that the flat side of the Washers
faces toward the Base Extrusion.
CAUTION
Use extra care to avoid pinching and damaging the sensor
wires that run alongside the Base Extrusion when installing and
tightening the mounting hardware.
4h
4
NOTICE:
This installation will require six Clipped
Washers (Part #2201725) from the Ulterra Bag
Assembly (Part #2994917).
i.
Slide the Base Extrusion into place on the Screws.
The Base Extrusion should slide between the Top
Plate and the Clipped Washers. Hold the Clipped
Washers up on the Screws so that the Clipped
Washers will sit on top of the Base Extrusion.
j.
With the motor in place, secure each Screw with a
Nylock Nut. Tighten with a 7/16” Box End or Open
End Wrench. Make sure all hardware is secure.
Base
Base
Extrusion
Extrusion
Top Plate
Top Plate
Clipped
Clipped
Washer
Washer
5i
5
ITEM(S) NEEDED
#C x 1
#4 x 6
#10 x 6
#6 x 6
Top Plate
Top Plate
Nylock Nut
Nylock Nut
5j