MINN KOTA 1810360, Manual

Page: 8 / 18

8 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
Completing the Installation
a. Begin with the Starboard Bracket already installed
to the Jack Plate. For specific instructions, please
refer to the installation for each type of Jack Plate
above. Once the Jack Plate Bracket is secured,
leave the hardware and Red Retainer in place until
instructed to remove it and continue below.
1
1a 1a
Transom Transom
Outboard Outboard
Outboard Outboard
Jack Plate Jack Plate
Bracket Bracket
Jack Plate Jack Plate
Bracket Bracket
Red Red
Retainer Retainer
Red Red
Retainer Retainer
Hardware Hardware
Hardware Hardware
2
b. With the help of a second person, position the
Built-in Mounting Bracket on the Raptor, so that
the hardware in the Red Retainer on the Starboard
Jack Plate Bracket aligns with the Mounting Holes
in the Built-in Mounting Bracket. Apply Anti-sieze
(Item #22) to the threads of the hardware held in
place by the Red Retainer. Then install the Built-in
Mounting Bracket to the hardware.
2b
2c
Starboard Starboard
Bracket Bracket
Mounting Mounting
Holes Holes
Jack Plate Jack Plate
Bracket Bracket
Flange Flange
Nuts Nuts
Built-in Built-in
Mounting Bracket Mounting Bracket
Built-in Built-in
Mounting Bracket Mounting Bracket
NOTICE:
The Red Retainer helps to align the
hardware in the Jack Plate Bracket with the
Mounting Holes in the Built-in Mounting Bracket
to aide in installation. Keep the Red Retainer in
place until instructed to remove it.
NOTICE:
It is recommended to have a second
person help with installation.
c. Take four of the Flange Nuts (Item #20) and place
one on the end of each of the Hex Head Cap Screws.
Secure them loosely.
Red Red
Retainer Retainer
Hardware Hardware
Red Red
Retainer Retainer
ITEM(S) NEEDED
#22 x 1 #20 X 4