Chapter 5. Machine adjustment and setting up
EN
PHASE 5 (Pratika 56, 56CS, 56MPE)
Feed the film between the two rollers (R3) and the two wheels (R4) on the feeder.
At this point perform a number of sealing cycles by pressing the “Sealing” key, so as to create a length of film that is
long enough to complete insertion as shown in the diagram. In order to seal the film you must close the front (C1) and
back (C2) guards.
Lastly, tie the film onto the pin attached to the rear flange (F).
PHASE 5 (Pratika 56 MPS)
Place the end of the film between the two wheels (R4) of the dragging device.
Been holding the “Conveyor belt movement” key pressed, the film is drawn inside the unit where it is sealed.
Press the “Conveyor belt movement” key until a sufficient strip of film is implemented to complete insertion according
to the layout shown.
Lastly, tie the film onto the pin attached to the rear flange (F).
53
Summary of Contents for MF21BA54
Page 90: ......
