41
ENGLISH
6. MAINTENANCE
• Clean the surfaces of the camera and monitor with a soft, lint-free cloth.
• If the units become dirty, use a lightly dampened cloth to wipe surfaces, taking care to not allow
water into any openings.
• Never use cleaning agents or solvents.
7. TROUBLESHOOTING
Problem
Possible Cause
Solution
No reception on the
monitor
Camera not turned on
Press and hold down button (III) for
2 seconds
Monitor not turned on
Press and hold down the Power
button (12)
Camera: not plugged in to the
power adapter
Plug in the power adapter
Monitor: The power adapter is
not plugged
Plug in the power adapter
Monitor out or range
Move the monitor closer to the
camera
Connection lost between the
monitor and a camera already
linked
Link the camera with the monitor
again. See 5.2.9.1.4
A wrong camera has been
selected
Change the camera number you are
watching. See 5.2.9.1.1
Only black and white
images are displayed
Check whether the camera is
in night vision/infrared mode
In order to view the images in colour,
increase the level of light in the room
the camera is in or check there is
nothing covering the camera´s light
sensor (II).
The camera does not
transmit
The camera is not turned on
Press and hold down button (III) for
2 seconds
Camera: the power adapter is
not plugged in
Plug in the power adapter
VOX mode or Standby mode
are active
To see the monitored area
continuously, disconnect the VOX or
Standby mode on the Monitor
You cannot hear the
baby on the parent unit
The volume setting of the
parent unit is too low
Set the volumen to the highest level
Interference or poor
reception
Other electronic devices may
be interfering with the signal
Move them away from the device
The camera and monitor may
be too far apart
Move the monitor closer to the
camera
The battery power may be too
low
Plug in the power adapter
Summary of Contents for digimonitor 2.4" plus
Page 8: ...MNLXX XXXXX ...
