OPERATING GUIDE
.
3. Click
.
4. Press
Download CSR
to download the CSR to your administration machine.
5. Send the CSR to a CA for certification. They will send a new certificate
6. Press
Upload
to upload the certificate to Smart 16 IP. The certificate uploads.
Important!
If you destroy the CSR on Smart 16 IP there is no way to get it back!
If you deleted it, repeat the above steps.
Telnet Settings
Enable Telnet access
- Access over Telnet client. For better security disable
Telnet access.
IP Access Control
This is used to limit access to a specific number of clients only. These clients are
identified by their IP addresses.
The IP access control settings apply to the LAN interface only!
Enable IP Access Control -
Enables access control based on IP source addresses.
Default policy
- Controls arriving IP packets that don't match any of the
configured rules. They can be accepted or dropped.
ATTENTION: If you set this to DROP and you have no ACCEPT rules
configured, access to the Web front-end over LAN is disabled! To enable access,
change the security settings via modem dial in or by temporarily disabling IP
access control with the initial configuration procedure (see page 4).
Rule #
- Type the rule number for which the following commands will apply.
This is ignored, when adding a new rule.
IP/Mask
- Specifies the IP address or IP address range for which the rule applies.
Numbers attached to an IP address with a `/' is the number of valid bits that are
used for the given IP address. Examples:
192.168.0.22 or 192.168.0.22/32 matches the IP Address 192.168.0.22
192.168.0.0/24 matches all IP packets with source addresses from 192.168.0.0 to
192.168.0.255
0.0.0.0/0 matches any IP packet
Policy
- Determines what to do with matching packets. They are accepted or
dropped.
40
.
Summary of Contents for Smart CAT5 Switch 16 IP
Page 79: ...OPERATING GUIDE 78 OPERATING GUIDE 78...
Page 80: ...SMART CAT5 SWITCH 16 IP 79...
