9
PROGRAMMING
PCB-001-388
REVISION A (09/2017)
The menu should have closed and been replaced with a smaller status box accompanied by another box en tled
‘In circuit programming’, see ‘Fig 1’. Ensure the PCB and the pogos have formed a connec on by applying light
pressure to the PCB taking care to not cause any bending. Select the ‘OK’ bu?on, this will start the device erase
process.
Fig 1
Fig 2
Providing the connec on is maintained throughout, the info box will turn certain areas green to indicate the
device has successfully erased, see ‘Fig 2’.
If a failure occurs repeat the erase a?empt.
The device can now be programmed. See PROGRAMMING SECTION for instruc ons.
PAGE 7
