User Manual of DH-300/400 Full Automatic Soldering Robot
24
The universal adjusting mechanism can be used for adjusting the wire outlet of
tin guiding pipe to align with the soldering surface tip of soldering bit.
1.
Loosen (1) to rotate (3) to the desired angle and then lock (1);
2.
Loosen (4) to vertically slide (2) to the desired height and then lock (4);
3.
Loosen (5) to rotate (6) to the desired angle and then lock (5);
4.
Loosen (7) to slide and rotate (8) in the hole and adjust the wire outlet to
the distance required by the tip of soldering bit, and then lock (7).
It is
suggested that the distance control should not be less than 8mm.
5.
Loosen (9) to slide and rotate (10) in the hole and adjust the air outlet of tin
blowing pipe to align with the tip of soldering bit so as to blow away the
residual molten tin.
6.
Loosen (11) to slide and rotate (12) in the hole. (12) is optional, and is not
configured in the standard configuration.
(4) Hexagon Socket Screw M3
(1) Hexagon Socket Screw M4
(2) Sliding Rod
(3) Rotary Column
(5) Hexagon Socket Screw M3
(6) Clamping Block for Tin
Guiding Pipe
(7) Hexagon Socket Screw M3
(8) Tin Guiding Pipe
(9)
Slotted
Set Screw M3
(10) Tin Blowing
Pipe
