MiNGARDi Micro One 230, Use And Installation Manual

Page: 9 / 17

GB
INSTRUCTIONS ON FITTING, USING AND
MAINTAINING THE ACTUATOR
Micro One
A05
Now secure the clamps to the frame using 4
screws code C094001600 (4.8x22 UNI 6954).
A06
Use the two spyglasses (pointed out in grey) on
the template for top-hung windows for drilling on
the wing. Use the same drill bit used for the
previous drilling.
Remove the two spyglasses from the template for
top-hung windows using the initiation shown in
darker grey as the breaking point.
A07
Fasten the front coupling CD20302700 to the wing
using 2 screws code C00795 (4.8x13 UNI 6954).
A08
Loosen the two screws holding the clamps
together so as to be able to insert the Micro One
actuator from the front. Once inserted, move it
horizontally while making sure that the front head
is perfectly housed inside the front coupling.
Afterwards, tighten the two clamp joining screws
with 4Nm
±
10% torque.
A09
Lastly, put on the elastic clip CD20303000.
-Connect the actuator to the electric system using
the enclosed diagrams and observing the safety
standards in force.
-Start the actuator to open the window, go to the
end of stroke and close again. This operation
tests that the actuator is working correctly, that the
limit switches trip and that the window is closing
properly.
Installation for windows with an overlapped part
measuring 5 to 10 mm:
A01
Find and mark the centre line of the window and
of the movable wing.
A02
Fit the top clamps code CD20302800 and bottom
clamps code CD20302900 on the template for
top-hung windows code CD20302500 and lock
them onto the template by screwing on the two
screws code A020300400-1 (M5x25 DIN 7984)
without tightening them with force.
A04s
Position this assembly while making sure that the
spacers are all the way up against the frame and
that they follow the profile; for horizontal
positioning, make the centre line coincide with the
indicator on the template (also refer to fig. A06).
Proceed with drilling by using the holes on the
bottom clamps as references; use those marked
by the symbol “*” on figure A04c. For aluminium
frame applications, drill with a 3.8-mm drill bit. The
fastening screws supplied are only for aluminium
frames. Contact the Mingardi S.r.l. technical
service for wooden, PVC or iron frames.
A05
A06
Use the two spyglasses (pointed out in grey) on
the template for top-hung windows for drilling on
the wing, which is necessary for fixing the front
coupling code CD20302700. Use the same drill bit
used for the previous drilling.
Remove the two spyglasses from the template for
top-hung windows using the initiation shown in
darker grey as the breaking point.
A07
Fasten the front coupling to the wing using 2
screws code C00795 (4.8x13 UNI 6954).
A08
Loosen the two screws holding the clamps
together so as to be able to insert the Micro One
actuator from the front. Once inserted, move it
horizontally while making sure that the front head
is perfectly housed inside the front coupling.
Afterwards, tighten the two clamp joining screws
with 4Nm
±
10% torque.
Now secure the clamps to the frame using 4
screws code C094001600 (4.8x22 UNI 6954).