24
①
Setting value writing response (Response 1)
The end of writing by the Setting value writing request (request 1) is notified.
ON : In completion of writing
OFF : After confirming OFF of Setting value writing request. (Request 1)
②
General command response (Response 2)
The end of the command order by the General command request (request 2) is notified.
ON
: In the completion of command order
OFF
: After confirming OFF of the General command request (Request 2)
③
Writing/Reading out selection response (R/W response)
The status of write/reading out is notified by command order when the General command response
(Response 2) is notified.
ON
: Reading out
OFF :
Writing
④
Operation mode changeover response (Response 3)
The end of changing operation mode by the Operation mode changeover request (Request 3) is
notified.
ON
: In the completion of the changeover
OFF
: After confirming the OFF of the Operation mode changeover request (Request 3)
⑤
CPU normal operation
CC-Link interface operating normally is
notified.
ON
→
OFF
→
ON reversing is notified at 0.5 seconds intervals
⑥
Decimal point position 1, 2, 4
The Decimal point position of the load value is notified by the 3 bits binary.
Position
Decimal point
position 1
Decimal point
position 2
Decimal point
position 4
None OFF OFF OFF
1 ON
OFF
OFF
2 OFF ON OFF
3 ON ON
OFF
4 OFF
OFF ON
⑦
Near Zero, and the other status
Statuses of Near Zero, F.Flow/S1, M.Flow/S2, D.Flow/S3, Over/S4, OK, Under, Stable, Finish, and
Full are notified.
⑧
Weighing value over
The occurrent of abnormal status (OL, OVF, -OL, -OVF) is notified when the stasus is over range.
ON
: In the occurrent of abnormal status
OFF :
Normal
