Minebea Intec IS16EDE-H, Installation And Operating Instructions Manual

Page: 8 / 40

8 Installation and Operating Instructions IS16/34/64EDE
Getting Started
The weighing platform is powered by the external industrial-grade ING 2 AC
adapter (see “Accessories”). Make sure that the voltage rating printed on this
unit is identical to your local line voltage. If the voltage specified on the label or
the plug design does not match the rating or standard you use, please contact
your local Minebea Intec office or dealer. To use a main feeder cable from the
ceiling or to mount a CEE plug, you will have to make arrangements inside your
facilities for installation of such cable equipment.
Use only original Minebea Intec AC adapters, identified by the Minebea Intec
label. Use of AC adapters from other manufacturers, even if these units have an
approval identification marking from a national testing laboratory, requires the
consent of a trained service technician.
For detailed information on further options for powering the equipment (e.g.,
using local low voltage), contact Minebea Intec headquarters in Germany or
one of the main offices based in your country.
The equipment must be connected to power in conformance with the
installation requirements of your country.
Safety Precautions
The Minebea Intec power supply rated to Industrial Class 2 (with safety extra-
low voltage emission (SELV)) can be plugged into any electrical outlet without
additional safety precautions. The ground or earth terminal is connected to the
platform housing, which can be additionally grounded, if required. Install the
power cable with adequate protection to prevent damage to the cable.
Fixed Power Connection
If the power cable is permanently installed or secured so that it cannot be
unplugged, an emergency switch must be installed for disconnecting power
to the equipment. This emergency switch must be located near the weighing
platform and must be easily accessible. In addition, this switch must be labeled
as an emergency switch. All operators must be instructed in the use of this
switch.
Whenever possible, avoid wiring your weighing platform into networks that carry
a heavy load (such as a connection to a compressor or similar equipment).