13. The “
About”
screen contains system information such as
Model,
Firmware, Bootloader, and Serial #.
14. Once Settings have been adjusted return to
Local Mode
main
screen by using the “
Back
” tab. When on this screen, the “
Pre-Acq
”
tab can be selected to move to the
Pre-Acquisition screen
.
15. The pre-acquisition screen shows the real time signals that are being read by the device. The
channels can be cycled through by using the
left and right arrow keys
. It is a good Idea to check
the signals in the acquisition screen before acquiring data. Note that the
“Back”
tab can be
selected to return to previous screens.
16. Once
Pre-Acquisition
has been reviewed, data collection can
begin by selecting the
“Acquire”
tab.
17. At this point, data is being recorded to the SD card.
Do not remove
SD card during acquisition.
16. During Acquisition, controls have been locked. To unlock them hold both the
“Left”
and
“Right”
arrow keys simultaneously.
17. When controls are unlocked signals can be viewed. Ending acquisition can be done on this
screen by selecting the
“Exit”
tab. All result will be saved to SD card.
WiFi Mode:
Wifi Mode allows the Mobile to stream acquisition data wirelessly to BioLab connected to a
network. This stores data to computer rather than a SD card. To do this a BioNex must be connected
to a computer with BioLab installed and open. See “BioLab Set-up” for more information.
1. Choose
Menu
from WiFi Mode main screen by selecting it with
right context button “B”
.
2.
This brings you to the
Main Menu
screen. Here you can change settings and power off the
device by using the arrow keys and selection buttons.
04
