Separate the velcro and reattach it at a cross angle.
Place the bottom plate on the table caster side down. Remove paper from the velcro
strip. With the velcro side down, place the battery holder along the center of the
bottom plate with the battery clip toward the caster mount end.
With the exposed axles toward the outside of the bottom plate, position the wheel
assemblies so that the notches of the wheel mounts fit directly into the holes of the
bottom plate. The white motor end should be facing in the direction of the caster mount
and the motors should be flush against the bottom plate. If motors are not flush, swap
the motor assemblies.
Position the top plate so that the notches of the motor mounts fit directly into the
holes of the top plate.
Copyright © 2015
mindsensors.com
7/12
