Screw the top plate down to the spacers, using four medium screws. Proper screw
placement is marked by red arrows in the image below.
Feelers:
Insert left feeler into the wisker hole on the left so that the right angle bends up
toward the top of the board.
The end of the bent side of the feeler should fit into the small hole (marked by the red
arrowin the image below) underneath the exposed copper plate of the board. Feeler
should be flush with the board and curling out toward the side of the board. If the
feeler is not flush with the board, ensure the bends are 90 degrees (right angles) with a
pair of pliers. If the feeler is curling in, put this feeler on the right side.
Hold the first feeler into place while inserting the second feeler.
Copyright © 2015
mindsensors.com
8/12
