9
Basic Operations
Turning Power On
Before you start to make measurements, check the
patient monitor, SMR and plug-in modules for any
mechanical damage and make sure that all external
cables, plug-ins and accessories are properly connected.
Plug the power cord into the AC power source. If you
run the patient monitor on battery power, ensure that the
battery is sufficiently charged.
Press the power on/off switch on the monitor’s front.
The start-up screens are displayed, and the technical
alarm lamp and alarm lamp are lit in blue and yellow
respectively. Then, the alarm lamp turns into red, and
turns off together with the technical alarm lamp after the
system gives a beep.
The monitor enters the main screen.
Starting Monitoring
Decide which measurements you want to make.
Connect the required modules, patient cables and
sensors.
Check that the patient cables and sensors are correctly
connected.
Check that the patient settings such as [
Patient Cat.
],
[
Paced
], etc, are appropriate for your patient.
Refer to the appropriate measurement section for details
of how to perform the measurements you require.
1.
2.
3.
4.
1.
2.
3.
4.
5.
Disconnecting from Power
To disconnect the patient monitor form the AC power
source, follow this procedure:
Confirm that the patient monitoring is finished.
Disconnect the patient cables and sensors from the
patient.
Make sure to save or clear the patient monitoring
data as required.
Press and hold the power on/off switch for above 2
seconds. The patient monitor shuts down and you
can unplug the power cable. If the patient monitor
does not shut down properly, press and hold the
power on/off switch for 10 seconds to shut it down.
1.
2.
3.
4.
Note
:
Make sure that the operating environment of the
patient monitor meets the specific requirements.
Otherwise unexpected consequences, e.g. damage
to the equipment, could result.
Do not use the patient monitor for any monitoring
procedure on a patient if you suspect it is not working
properly, or if it is mechanically damaged. Contact your
service personnel or us.
