Mimio MimioProjector, Service Manual

Page: 60 / 98

4-9 MimioProjector Service Manual
Chapter 4: Function Test&Alignment Procedure
4-5 Run In Test
- Temperature: 15°C~35°C
- Circumstance brightness: Normal environment
- Screen size: No concern
- Display mode: ECO mode
After repairing each unit, a Ru
n-in test is necessary (refer to the below table).
Symptom Run-in Time
Normal repair 2 hours
NFF 4 hours
Auto shutdown 6 hours
- Get into Burn-In Mode
* Cycle setting is based on the defect symptoms. ie: If it is NFF, the run-in time is 4 hours.
You have to set the lamp on for 50 min. and lamp off for 10 min for 4 cycles.
Press Power > Left >Right > Menu buttons sequentially on remote controller or kyepad to get
into service mode
Choose Burn-In Test > enter
Lamp On
Press right key to adjust the time (50)
Lamp Off Press right key to adjust the time (10)
Set burn in cycle Press right key to adjust the cycle
After setting up the time, choose “Get into Burn-In Mode” and press enter