MIMAKI JV3-130 SP II, Operation Manual

Page: 80 / 144

- 4.6 -
MEDIACOMP. P.2-20
When the media type or heater temperature is changed, be sure to correct the amount of feed
according to the media thickness.
(-255-255)
HEATER (Temperature setting during plotting P.2-18 )
Sets the printer heater and preheater built in the platen.
PRE HEAT :
Sets the temperature of the preheater.
(OFF, 20- 60
o
C / 68- 140
o
F)
PRINT HEAT :
Sets the temperature of the printheater.
(OFF, 20- 60 o C / 68- 140 o F)
o C / o F :
Selects the unit of temperature.
( o C / o F )
STANDBY :
Sets the time interval since when plotting is completed till when the heater temperature
begins to drop to the preheat temperature. The preheat temperature is preset and cannot
be changed. When plotting is started when the temperature has dropped, it rises up to
the set temperature automatically.
When [NONE] is selected, the temperature does not drop to the preheat temperature.
(NONE, 10- 90 min /10min step)
OFF TIME :
The heater is turned off in the following cases:
• If the device does not plot for the setup time or longer in the standby mode.
• With STANDBY-[NONE] selected, when plotting is started with the heater off if the
device does not plot for the setup time of longer after the end off plotting, the temperature
rises up to the set temperature automatically.
With [NONE] selected, the heater is not turned off.
(NONE, 30, 60, 90 min.)