MIMAKI CG-100EX, Operation Manual

Page: 99 / 110

– 4.7 –
* DIVISION * 5s
** DIVISION **
* END DIVISION *
RS1 CSO DRO ER1
The device has finished the cutting
of data that exceeds the sheet width
using the division cut and is now
waiting for the receipt of
next data.
You have made the device to enter
the remote mode during the division
cut without establishing an origin or
replacing the sheet.
This message appears in the
following cases.
• In the case where the device has
received data that contains the
origin updating command
(ZT;, !PG;)
• In the case where the sheet width is
1 cm or less
• In the case where the sample
cutting data exceeds the sheet
width
• In the case where the two-point
axis alignment is set to ON
The display change-over for the
remote mode has been set to [RS-
232C]. (See page 3.25.)
Message Cause Action
If the device does not receive any
data from the host computer within
ten seconds, it will recognize the
data has ended. Then, the device
will perform the frame cutting and
mark cutting and enter the local
mode.
Establish an origin or replace the
sheet. Then, set the device in the
remote mode.
Division cut is disabled.
Change over the display, where
necessary.