MIMAKI CG-100EX, Operation Manual

Page: 46 / 110

– 2.24 –
Sheet detection
The width and length of the sheet is detected by pressing the arrow keys or key in accordance
with the sheet loaded.
* Once the length of a sheet of media has been detected, if the received data is
larger than the sheet, only the portion of data that exceeds the sheet will not be
cut.
If the length of a sheet of media is not detected, the device will terminate cutting
operation at the time when data goes beyond the sheet.
* If the sheet sensor feature is set to the [OFF], a press on , , or
key will cause the device to perform the same sheet detection as with the case
where the key is pressed.
The setting direction of the media is rendered effective.
* The maximum length that can be detected at the front and rear ends of the sheet
of media is 3 m.
The position to
start detection
END
END
Method to detect a sheet
When a sheet of media is retained with the pinch rollers, the following two displays will appear
alternately on the LCD panel.
Select the key in accordance with the direction of the sheet loaded on the device.
When detecting the rear end of the sheet
Max. 3 m
The origin after
the detection
The origin after
the detection
Max. 3 m
Front end of
the sheet
Front end of
the sheet
When detecting the front end of the sheet
ROLL < R > LEAF ROLL F LEAF
<
<