6
ASSEMBLY
WARNING
Recharge only with the charger
specified for the battery. For spe
-
cific charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push the battery latch lock
to the side and squeeze the battery latch lever. Pull
the battery pack away from the machine.
WARNING
Always remove the battery pack
any time the tool is not in use.
To
insert
the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
WARNING
Only use accessories specifically
recommended for this machine.
Others may be hazardous.
Locking the Trigger
To
lock
the trigger, slide the trigger lock to the locked
position.
To
unlock
the trigger, slide the trigger lock to the
unlocked
position.
The trigger will not work when the trigger lock is in
the locked position.
Always lock the trigger and unarm the machine or
remove the battery pack before performing mainte-
nance, changing accessories, storing the machine,
and any time the machine is not in use.
Fuel Gauge
When the machine is armed, the Fuel Gauge displays
the battery pack's remaining run time. The fuel gauge
mirrors the fuel gauge on the battery pack. When less
than 10% of charge is left, 1 light on the fuel gauge
will flash. When the battery reaches 0% charge, the
fuel gauge will flash 8 times. Charge the battery pack.
Less than 10% if first light flashes 4 times
10-32% 32-55%
55-77%
77-100%
WARNING
To reduce the risk of injury, use a
cut-off wheel which is rated with a
maximum safe operating speed at least 5370 RPM.
READ SAFETY INFORMATION SUPPLIED WITH
CUT-OFF WHEEL. Always wear proper safety
equipment, including a dust mask.
Installing and Removing Cut-Off Wheels
1. To
install
cut-off wheels, remove battery pack.
2. Place machine on a firm surface.
3. Move wheel guard for easier access to spindle bolt.
4. Slide the inner flange, arbor adapter, cut-off wheel,
and outer flange over the spindle. Be sure the
arbor adapter matches the wheel arbor hole size
(20 mm or 1").
Spindle Bolt
Outer flange
Inner
flange
Spindle
Arbor adapter
Wheel
5. While holding the spindle lock in place with the
hex wrench (1), install and tighten the spindle bolt
securely with the scrench (2).
1
2
6. To
remove
cut-off wheels, hold the spindle lock
in place and loosen the spindle bolt with the
scrench. Remove the spindle bolt, outer flange,
arbor adapter, and cut-off wheel.
Adjusting the Wheel Guard
WARNING
To reduce the risk of injury when
cutting, ALWAYS adjust the guard
to provide the best control and protection. Wear
gloves to protect hands when adjusting the
guard.
1. To
adjust
the guard,
remove battery pack.
2. Grasp the wheel guard
handle and rotate for-
ward or backward (45º
range). Always position
the guard in the loca-
tion which offers best
control and protection.
ONE-KEY™
To learn more about the ONE-KEY™ functionality
for this tool, go to milwaukeetool.com/One-Key. To
download the ONE-KEY™ app, visit the App Store or
Google Play from your smart device.
ONE-KEY™ Indicator
Solid Blue
Wireless mode is active and ready
to be configured via the ONE-KEY™
app.
Blinking Blue Machine is actively communicating
with the ONE-KEY™ app.
Blinking Red
Machine is in security lockout and
can be unlocked by the owner via
the ONE-KEY™ app.
