4
Mounting the Cut-Off Machine
WARNING
Remove battery before mounting
cut-off machine.
Use only with MX
FUEL
TM
Cut-Off Machines.
1. Unlatch and swing open the mounting cover .
2. Place machine onto mounting hook (1) and posi-
tion machine trigger above the trigger lever pull
on cart (2). Adjust rear alignment as needed (see
"Rear Alignment Adjustment").
1
2
3. Secure both mounting cover latches.
4. Connect water supply to machine according to
Cut-Off Machine instructions
Rear Alignment Adjustment
To maintain a straight line and
avoid veering off-course while
cutting, adjust the rear align-
ment knob (located inside the
handle cover) as necessary.
Secure the mounting cover
before starting work.
OPERATION
WARNING
To reduce the risk of injury, always
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Surface Cutting
1. Clear debris from the path of the cart. Debris can
hinder or damage the wheel.
2. Arm the cut-off machine. Follow all instructions and
warnings provided with the cut-off machine
3. Open the water supply line to the machine.
4. The cart uses a mechanical lever system to
engage the cut-off machine's trigger. To start the
cut-off machine, press the "1" button (1) while
pulling the throttle lever (2). The further the lever
is pulled, the faster the wheel will spin. Release
lever to stop.
SYMBOLOGY
Read operator's manual
Always wear eye protection. Use
appropriate hearing and respiratory
protection.
Regulatory Compliance mark (RCM).
This product meets applicable
regulatory requirements.
SPECIFICATIONS
Cat. No. ................................................
MXF COSC
Recommended Tank Capacity
.....
...
....
11 L
(
3 Gal
)
Use with ................... MX FUEL
TM
Cut-Off Machine
ASSEMBLY
Moving Cart into Working Position
1. Loosen handle locking knob (1) and move push
handle (2) into upright working position. Tighten
handle locking knob (1).
1
2
3
2. Squeeze the cutting depth adjustment handle (3)
and move into upright working position.
3. Mount the 3 gallon water tank using the two lock
latches (4).
4
To reduce the risk of fire,
ADDITIONAL BATTERY SAFETY RULES
WAR
NIN
G
personal
injury , and product damage due to a
short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow
inside them. Corrosive or conductive fluids,
such as seawater , certain industrial chemicals,
and bleach or bleach-containing products, etc.,
can cause a short circuit.
