4
Pressing
• Before beginning a press, inspect the jaw assembly
for cracks or other damage. Do not use a damaged
jaw assembly. Return damaged jaw assembly to the
store where the product was originally purchased or
one of our authorised MILWAUKEE® FORCELOG-
IC™ service centres.
• Before beginning a press, check the fuel gauge to
determine whether the battery charge is sufficient to
complete the pressing operation.
• The tool will turn off automatically after 30 minutes
of no use.
• Inspect and discard workpieces with cracks or wear
before use. Materials may crack or shatter.
1. Turn the tool ON
by quickly pressing
and releasing the
start button.
2. Open the jaws and
place around the
fitting.
3. Hold tool securely.
Press and hold the
start button. The
green LED will go
out.
4. T h e a u t o m a t i c
press cycle begins.
Release the start
button and contin-
ue to hold the tool
securely.
5. When the press
cycle is complete
the tool will switch
off and the green
LED will light.
6. To cancel the automatic press cycle, press and hold
the release button. Hold tool securely until jaws
open and the tool turns off.
7. If the tool is in use for 30 minutes continuously
(e.g., on a manufacturing fixture), allow the tool to
cool down for at least 15 minutes before continu-
ing. Under normal use (e.g., plumbing/mechanical)
press freely and pay attention to the LED indicators
(see "Troubleshooting").
8. If the red LED lights, press the start button. If the
tool does not run, return the tool to the store where
the product was originally purchased or one of our
authorised MILWAUKEE® FORCELOGIC™ service
centres.If the red and green LEDs flash alternately,
the tool must be serviced by a MILWAUKEE
®
FOR-
CELOGIC™ service facility.
9. If the red and green LED's flash alternately, the
tool must be serviced by one of our authorised
MILWAUKEE® FORCELOGIC™ service centres.
OPERATION
WARNING
Always remove battery
pack before changing or removing acces-
sories. Only use accessories specifically
recommended for this tool. Others may be
hazardous.
WARNING
To reduce the risk of injury,
wear safety goggles or glasses with side
shields.
ASSEMBLY
WARNING
Recharge only with the
charger specified for the battery. For specific
charging instructions, read the operator’s
manual supplied with your charger and battery.
Inserting/Removing the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Always remove battery
pack before changing or removing acces-
sories. Only use accessories specifically
recommended for this tool. Others may be
hazardous.
Inserting/Removing the Crimping Head
1. Pull out the retaining pin.
2. Insert the crimping head.
3. Push in the retaining pin (1).
CAUTION
To avoid damage to the tool,
do not operate the tool without the retaing
pin fully inserted. Damage to the cylinder
may occur.
*Milwaukee jaw sold separately