3
•
•
SYMBOLOGY
Volts
Direct Current
No Load Revolutions per Minute (RPM)
Read Operator's Manual
SPECIFICATIONS
Cat. No. ............................................. M12 BSTP 0
Volts........................................................... 12V DC
Battery Type .................................................M12™
Charger Type................................................M12™
Max Flow Rate........................ 34 Litres per minute
Fitting ..................................................
3/4"-14 BSPT
Application
Max Water Temperature ................. 60°C (140°F)
Max Air Temperature ...................... 40°C (104°F)
Recommended Ambient
Operating Temperature ................... -17°C to 51°C
WARNING
recommended for this tool. Others
may be hazardous.
Connecting the Hose
• Use a hose with a
3/4"-14 BSPT
fitting. To prevent
leaking, ensure the hose has a properly-working
o-ring in its fitting.
•
• A regular garden hose may be used as an outlet
hose.
• Make sure connections are tight.
•
Removing/Installing the
HydroPass Filter
Regulatory Compliance Mark (RCM).
This product meets applicable
regulatory requirements.
Do not dispose of electric tools
together with household waste
material. Electric tools and electronic
equipment that have reached the end
of their life must be collected
separately and returned to an
environmentally compatible recycling
facility.
ASSEMBLY
WARNING
Recharge only with the charger
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove the battery pack
any time the tool is not in use.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
FUNCTIONAL DESCRIPTION
1. ON/OFF switch
2. Handle
3. Submersion line
4. Lift tube
6
1
5. HydroPass filter
6. Battery bay
7
4
2
5
3
Always use common sense and be cautious
when using pump.
It is not possible to anticipate
every situation that could result in a dangerous
outcome. Do not use this pump if you do not
understand these operating instructions or you
feel the work is beyond your capability; contact
MILWAUKEE
®
Tool or a trained professional for
additional information or training.
Maintain labels and nameplates.
These carry
important information. If unreadable or missing,
contact a
MILWAUKEE
®
service facility for a
replacement.
7. Hose fitting
For best results, a heavy duty hose should be
used to prevent the hose from collapsing. Use a
shortlength, large diameter hose, such as a 1.8 m
(6') long, 1.9 cm (3/4") inner diameter garden
hose. Longer or thinner hoses may reduce
performance and flow rate.
To remove the HydroPass filter, hand twist the filter
anti-clockwise and pull it away from the rest of the
tool.
To install the HydroPass filter, line the filter up at the
end of the lift tube and hand twist the filter clockwise
until it is fully connected with the rest of the tool. Do
not overtighten.
NOTE:
The HydroPass filter must be installed to
use the pump.
Hand thread the outlet hose onto the pump's
hosefitting. Do not overtighten, or the threads may
be damaged on the fitting or hose.
ADDITIONAL BATTERY SAFETY RULES
WARNING
WARNING
To reduce the risk of fire, personal
injury, and product damage due to
a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside
them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a
short circuit.
Do not charge non-rechargeable
batteries.
V
