3
funcTional descripTion
specificaTions
Direct Current
symbology
To prevent electric shock, do not allow
product to contact live electrical parts
User must read operator’s manual
Wear eye protection
1. Camera
2. Camera LEDs
3. Cable
4. Rotating LCD
5. Fuel gauge
6. Power button
7. LED brightness
increase/decrease
buttons
assembly
Warning
Recharge only with the
charger specified for the battery. For
specific charging instructions, read the
operator’s manual supplied with your charger
and battery.
Inserting/Removing the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Attaching/Removing Accessories
To attach an accessory, hook the two front hooks
over the front of the camera. Press the clip over the
back end of the camera to snap it into the detents.
To remove, pull up on the clip and then unhook
the accessory.
Cat. No. volts
DC
Cable Length
M12 IC
12
2.7 m
Clip
Detent
4
5
3
6
7
1
2
operaTion
Warning
To reduce the risk of injury,
wear safety goggles or glasses with side
shields. Always remove battery pack before
changing accessories or making adjustments.
Turning On/Off
Press the Power button to turn the tool on. Press
and hold the Power button to turn the tool off.
Sleep Mode
The tool will shut off automatically if unused for 5
minutes. To reset, press the Power button again.
Fuel gauge
To determine the amount of charge left in the bat-
tery, turn on the tool. The Fuel Gauge will light up
for 2-3 seconds.
To signal the end of charge, 1 light on the fuel gauge
will flash for 2-3 seconds.
Camera LED
The camera LEDs can be adjusted to 4 levels
of brightness and turned off. Press the camera
LED brightness increase and decrease buttons to
change the level of brightness or turn it off.
Hooks
