Milnor 36026X8J, Installation And Service, Page: 38 / 126

Preventive Maintenance
PELLERIN MILNOR CORPORATION
3.
Preventive Maintenance
Table 1: Preventive Maintenance Checklist
Components Action Frequency Specifications/References/Figures
Main Bearing
Housing
Bearings Slowly grease, 2
strokes - 0.12 fluid
ounces (3.54 grams) at
two locations.
Monthly
Water seals Slowly grease, 1
stroke - 0.06 fluid
ounces (1.77 grams) at
one location.
Monthly
Shell Alvania EP (or equivalent). See
"Bearing Housing Maintenance
Points."
Drive Train Drive belts Inspect belt(s) and
pulley for wear. Test
belt tension.
Every four
months
See "Drive Belt Service and Service
Notes" in this section.
Inverter fans and
vents
Verify fan operation
and vacuum out vents.
Monthly See "Drive Train Maintenance
Points."
Suspension Rubber springs Inspect for cracks and
deterioration.
Monthly See "Suspension Maintenance
Points."
Ball bushings Slowly grease, 1
stroke - 0.06 fluid
ounces (1.77 grams) at
one location.
Every two
months
Shell Alvania EP (or equivalent). See
"Suspension Maintenance Points."
Shocks Inspect for leaks and
deterioration.
Every four
months
See "Suspension Maintenance
Points."
Foundation Bolts Check bolts for
tightness and wear.
Tighten or replace as
necessary.
Every four
months
Dimensional drawings
Chemical Supply
(if so equipped)
Supply hoses Inspect for leaks and
deterioration, observe
operation.
Every four
months
Flushing supply
injection valve
strainers (if so
equipped)
Inspect and clean the
strainers in supply
injector valves and
clean out each
compartment.
See "Service Notes" in this section
Steam Steam strainer (if so
equipped)
Inspect and clean
strainer
Every four
months
4.
Drive Belt Service
Check tension for a new belt according to the following schedule and tighten belt if needed, as
described below.
• After 24 hours operation (three eight-hour shifts)
• After 80 hours operation (ten eight-hour shifts)
• After 160 hours operation (twenty eight-hour shifts)