OM-245778 Page 26
8-2.
Replacing Hub Assembly
246 218-C / Ref. 143 223-A
Remove gun top cover and release
pressure arm.
Retract wire onto spool and remove
spool. Take hub apart as shown.
1
Metal Brake Washer
2
Fiber Washer
3
Brake Washer
4
Hub
5
Keyed Washer
6
Spring
7
Flat Washer
8
Cap Screw
9
Retaining Ring
Replace broken or worn parts and
slide parts onto shaft as shown.
Adjust hub tension and thread
welding wire. Close and latch door.
Close gun pressure roll assembly
and reinstall gun cover.
Tools Needed:
7/16 in.
1
2
3
4
5
6
7
8
9
8-3.
Diagnostics
The following error messages are shown on the left and right displays to indicate specific errors. Explanations are in the text below:
TRIG
ERR
Indicates a trigger error. A trigger error occurs if the user has the trigger held for more than two
minutes without striking an arc. This error also occurs if the trigger is held when the feeder is powered
up. The error may be cleared by releasing the trigger.
JOG
ERR
Indicates a jog switch error. A jog switch error occurs if the user has the jog switch held for more than
two minutes. This error also occurs if the jog switch is held when the feeder is powered up. The error
may be cleared by releasing the jog switch.
PURG
ERR
Indicates a purge switch error. A purge switch error occurs if the user has the purge switch held for
more than one minute. This error also occurs if the purge switch is held when the feeder is powered
up. The error may be cleared by releasing the purge switch.
COOL
ERR
Indicates a water flow switch error. A water flow switch error occurs if no water flow is detected while
the trigger is pressed. Jog and purge switches will behave normally even if no water flow is detected.
Dip switch 2 on the motor control pcb must be set to enable this error. The error is cleared when wa-
ter flow is detected or when the error is disabled.
TEST
ERR.1
Indicates a power on self diagnostic test error. The number provides information regarding the error.
If this error occurs, contact a Factory Authorized Service Agent.
COMM
ERR
Indicates a serial communication error. A communication error occurs 2 seconds after a loss of com-
munication between the motor control pcb and the front panel pcb.
G.CAL
ERR.1
Indicates a gun calibration wire restriction error. This error occurs if the detected wire speed during a
calibration is too slow. This error will not prevent the feeder from operating, but wire speed accuracy
may be compromised. See section 8-4.
G.CAL
ERR.2
Indicates a gun calibration wire slip error. This error occurs if the detected wire speed during a calibra-
tion is too fast. This error will not prevent the feeder from operating, but wire speed accuracy may be
compromised. See section 8-4.
1234
ERR.M
Indicates a motor control pcb error. If this error occurs, contact a Factory Authorized Service Agent.
1234
ERR.F
Indicates a front panel pcb error. If this error occurs, contact a Factory Authorized Service Agent.
