IVA-
Section IVA - OPERATING INSTRUCTIONS
WHEEL LIFT (cont'd)
(b) Reduce truck's engine to an idle and apply parking brake. Depress
clutch, place transmission in neutral and engage Clutch pump
by pulling Clutch pump control knob located in cab. When
engaged, the Clutch pump indicator light in the cab will illuminate.
Refer to Figure 4..
NEVER DRIVE TRUCK ON STREET WITH CLUTCH PUMP
ENGAGED, THIS CAN CAUSE PUMP FAILURE DUE TO
OVER-SPEED AND OVERHEATING.
(c) Adjust engine speed to desired RPM (recommended 400 to
500) using the electronic throttle control in cab of truck.
DO NOT EXCEED 1500 RPM
4A.3 VEHICLE HOOK UP
(a) Lower Wheel Lift Boom to the horizontal position using the
WHEEL LIFT FOLD "UP-DOWN" Control, and then lower Wheel
Lift to ground and raise until Wheel Lift just clears ground level
by use of the BOOM "UP-DOWN" Control. See Figure 4A..
BE SURE YOU ARE CLEAR OF THE WHEEL LIFT
BOOM, CROSSBAR AND CLAWS
WHEN THE WHEEL LIFT IS LOWERED.
Summary of Contents for Vulcan 810 NYC
