Miller Syncrowave 250 DX, Owner'S Manual

Page: 13 / 82

ENGLISH
OM-363 Page 7
SECTION 3 − INSTALLATION
3-1. Serial Number And Rating Label Location
The serial number and rating information for the power source is located on the rear of the machine. Use the rating labels to determine input power
requirements and/or rated output. For future reference, write serial number in space provided on back cover of this manual.
3-2. Selecting A Location
OR
2
Movement
!
Falling Unit Can Cause Injury.
Use lifting eye to lift unit only, NOT
running gear, gas cylinders, or any
other accessories.
Use equipment of adequate capacity
to lift and support unit.
If using lift forks to move unit, be sure
forks are long enough to extend
beyond opposite side of unit.
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to move unit.
If using lifting forks, extend forks beyond
opposite side of unit.
3 Line Disconnect Device
Locate unit near correct input power supply.
!
Special installation may be required
where gasoline or volatile liquids
are present − see NEC Article 511 or
CEC Section 20.
!
Do not move or operate unit where
it could tip.
Location And Airflow
3
1
18 in
(460 mm)
18 in (460 mm)
1
Ref. 117 264-C / 803 584-B