Miller ProHeat 35 OM-222 166F, Owner'S Manual

Page: 52 / 72

OM-222 166 Page 46
RemCmd: 1023 Off Cable1: LQD DIAG1
OutI1: 0 A Cable2: LQD
OutI2: 0 A ClntFR: 0.75 GPM
IsrcFb: 0 A ClrSts: Flowing
System Diagnostic Screen
RemCmd − This is the value of the remote command and the status of the remote contactor.
Remote controls can be used to enable/disable output. They do not affect output
power level.
NOTE
Out I1 − This is the value of the output current on output 1.
Out I2 − This is the value of the output current on output 2.
Isrc FB − This is the value of the amperage in the current source inverter.
Cable 1 − This is the cable type hooked up to output number one. Possible labels:
S AIR − for an air-cooled cable
S LQD − for a liquid-cooled cable
S
PLUG − for a protective plug
S OPEN − no cable or plug in place
Cable 2 − This is the cable type hooked up to output number two. Possible labels:
S AIR − for an air-cooled cable
S LQD − for a liquid-cooled cable
S PLUG − for a protective plug
S OPEN − no cable or plug in place
ClntFR − This is the coolant flow rate (in GPM) from the cooler on a liquid-cooled system.
ClrSts − This is the status of the cooler. Possible labels:
S Off
S Flowing
The second diagnostic screen is available by again pressing and holding the Run Status button and pressing
the Parameters
Hz
V
A
kW
button.
VLnA − B: 460V Therm1: 75 DIAG2
VLnB − C: 460V Therm2: 75 Therm5: OPEN
VLnC − A: 460V Therm3: 75 ClrTmp: 77
VBus: 650V Therm4: OPEN RmtFlw: Off
System Diagnostic Screen