Miller PipePro XC, Owner'S Manual

Page: 39 / 72

OM-269631 Page 33
5-20. Installing And Threading Welding Wire
Ref. 250 764-A
Installing Wire And Adjusting
Hub Tension:
1 Retaining Nut
2 Hub Tension Adjustment
Screw
Remove retaining ring, and install
spool so hub pin fits spool hole. Re-
install retaining nut.
Adjust tension nut so only a slight
force is needed to turn spool.
Threading Welding Wire:
3 Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
Open pressure assembly, hold wire
tightly, and cut off end. Push wire
through guides into gun.
Close and tighten pressure assem-
bly. Press Jog switch until wire
comes out gun.
Feed wire against wooden surface,
and tighten knob so wire does not
slip.
Cut off wire, and close door.
Tools Needed:
Pull and hold wire; cut off end.
6 in.
(150 mm)
WOOD
Tighten
Clockwise
.
Hold wire tightly
to keep it from
unraveling.
1
2
3