OM-240 113 Page 40
10-3. Mounting Unit
Tools Needed:
9/16 in
2
2
4
Welding Unit In Place
Bolting Unit In Place
NOTICE
−
Do not mount unit by
supporting the base only at the four
mounting brackets. Use cross-sup-
ports to adequately support unit
and prevent damage to base.
.
See Section 4-5 for dimen-
sions.
Mounting Surface:
1
Cross-Supports
2
Mounting Brackets (Supplied)
Mount unit on flat surface or use
cross-supports to support base.
Secure unit with mounting brack-
ets.
3
1/2 in Bolt And Washer
(Minimum
−
Not Supplied)
4
3/8-16 x 1 in. Screws
(Supplied)
To Bolt Unit In Place:
Remove hardware securing the
four mounting brackets to the base.
Reverse brackets and reattach to
base with original hardware.
Mount unit to vehicle with 1/2 in. (12
mm) or larger hardware (not sup-
plied).
To Weld Unit In Place:
Weld unit to vehicle only at the four
mounting brackets.
1
2
Supporting The Unit
Using Mounting Brackets
Ref: install3 2008--01 803 274 / 200 864-A / 803 231
1
OR
3
